Superior Systems & Installations1,Inc.

Description

Description

Amplifier Description

The 10.0kw competition series amplifier is a 10,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power.

It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

Output Power (RMS)

4 ohm 3000Wx1 @ 14.4 Volts

2 ohm 5500Wx1 @ 14.4 Volts

1 ohm mono 10,000×1 @ 14.4 Volts

DO NOT CHARGE OVER 15.3Volts

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired Bass Knob remote control W/ Clip Light

• RCA Pass Thru

• Linkable

• Triple 0 Awg Power Ground Inputs

Recommended for installation :

2 Upgraded Alternators or 350 amps of charging power

Upgraded under hood Battery

1000ah of AGM Batteries in the trunk or 140ah Lithium

Dash mounted voltage meter

0 Awg OFC power and ground

Power & ground runs from front to back batteries.

DO NOT mount to subwoofer box. (will void warranty)

AMP SPECS:

DC Amp Model: 10.0k
Input Sensitivity 6V~0.2V
Frequency Response 15Hz~270Hz
24dB / Octave Crossover YES
Low Pass 35Hz ~ 250Hz
Subsonic Filter 10Hz-50hz
Bass Boost @45hz 0 ~ 9db
Phase Shift 0 ~ 180
Remote Control Yes
Clip Indicator Yes
Signal to Noise Ratio dB100
Damping Factor 150< THD @ 4ohms Less than 0.1% Fuse Rating External 350 amp x 3 LED Status Lights Power and Protect Master/Slave Yes Heatsink Length 34.64"/880mm Heatsink Width 11.5"/292mm Heatsink Height 2.6"/66mm